KICKER 45KM102 10" 350w Marine Boat Subwoofer Sub KM10 + Hifonics Mono Amplifier
Shipping calculated at checkout.
Product Description
- (1) Kicker 45KM102 10" 350w Peak/175w RMS Marine Boat Subwoofer SVC 2-ohm Sub KM10
- (1) Hifonics TPS-A500.1 500w Mono Marine Sub Amplifier For Polaris RZR/ATV/UTV/Cart
Authorized Kicker Dealer!
What's In The Box:
- (1) 10" Woofer
- (1) Back Gasket
- (8) Mounting Screws
- (8) Mounting Screw Clips
- (1) Owner’s Manual
Description of 45KM102:
The KICKER® KM 10-inch Marine Subwoofer is made to work perfectly in a sealed or ported enclosure. Packed with features and made for marine, KICKER gives you the deep, loud bass your boat needs with KM subs.
Features:
- KICKER 45KM102 10" 350w Peak/175w RMS Marine Subwoofer SVC 2-Ohm
- RMS Power Handling: 175 Watts
- Peak Power Handling: 350 Watts
- Two-Ohm Voice Coil
- Injection-Molded Polypropylene Cone
- Co-molded Santoprene® Surround
- UniPlate™ Back Plate And Pole Piece
- Thick Tinsel Leads
- Large Ceramic Magnet
- Rear Gasket Included
- Polymer Basket Resists Corrosion
- Protective Terminal Cap
- Stainless Mounting Hardware Included
- Meets or Exceeds ASTM Standards for UV and Salt/Fog Exposure
- Frequency Response: 30 Hz - 500 Hz
- Impedance: 2 Ohms
- Mounting Depth: 5" inches
- Hole Diameter: 9 3/16"
-
Sealed Enclosure Volume Min-Max: 1-2.4 cubic feet
Description of TPS-A500.1:
Hifonics THOR compact 500 watt mono Powersports amplifier to for a subwoofer with on-board equalization and simple instalation with quick release connectors.
Features:
- Hifonics TPS-A500.1 500w Mono Marine Sub Amplifier For Polaris RZR/ATV/UTV/Cart
- Marine Grade Protection: YES - Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
- Pre-Amp Circuitry: Low Noise Pre-Amplifier Stage - Special preamplifier reduces incoming noise from source units dramatically improving sound quality
- Inputs: 1 Pair, RCA Nickel-Plated - High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
- Operation Mode: Mono operation - Designed to power 1 subwoofer or subwoofer system
- Crossover / Signal Shaping: LPF - Complete control of amplifier signal, essential when using two or more amplifiers
- Class / Topology: Full Range Class D - Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
- Output Devices Technology: PWM MOSFET Power Supply - Stable power through the PC board with minimal heat generation
- Heat Sink: Aluminum - Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration
- Power Supply: Simpatico Coil Design - The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
- Output Connections: Quick Dissconect Wires, RCA Connections - Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
- Connections Type: Gold-plated connections - Gold-plated power, ground, speaker and RCA corrosion resistant connections
- Diagnostics: Three-stage protection circuits - Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel
- Marinized / Waterproof: YES - Water resistant for durability in any environment
Specifications:
- Class: Full Range Class D
- Variable Voltage: 0.2V~9V
- Signal to Noise Ratio: >100dB
- Frequency Response: 10Hz-300Hz
- Crossover Type: Electronic 12dB Per Octave
- Crossover Frequency Range CH1 & CH2: Switch Low Pass 300 Hz
- Bass Boost: 0-12dB@45Hz
- Subsonic Filter: 60Hz
- Power @ 2-Ohms: 1 x 500W
- Power @ 4-Ohms: 1 x 250W
- Total Channels: Mono
- Audio Inputs: RCA
- Power Terminal 12v/GND: Molex 10 ga
- Speaker Terminal Wire Gauge: Molex Plug Connector
- Fusing: 1 x 30 Amps
- Certifications: Marine & Powersports
- Dimensions: 3.70 X 5.51 X 1.77 inches (9.4 X 14.0 X 4.5 cm)
- Weight: 2.09 lbs (0.95 kg)
Shipping & Returns
Row content
