KICKER 45KMF102 10" Free Air Marine Subwoofer Sub KMF10+Hifonics Mono Amplifier

Package Includes:

• (1) Kicker 45KMF102 10" 350w Peak/175w RMS Marine Boat Subwoofer Freeair Sub KMF12
• (1) Hifonics TPS-A500.1 500w Mono Marine Sub Amplifier For Polaris RZR/ATV/UTV/Cart

---

Authorized Kicker Dealer! 

What's In The Box:

• (1) 10" Woofer
• (1) Back Gasket
• (8) Mounting Screws
• (8) Mounting Screw Clips
• (1) Owner's Manual

Description of 45KMF102:

The KICKER® KMF 10-inch Marine Subwoofer makes serious bass - no enclosure necessary! Made to take the power and the weather, this sub is custom made to bang in your boat. Packed with features and made for marine, KICKER gives you the deep, loud bass your boat needs with the KMF series of subs.

Features:

• KICKER 45KMF102 10" 350W Peak/175W RMS Marine Subwoofer KMF12
• Peak Power Handling: 350 Watts
• RMS Power Handling: 175 Watts
• Two-Ohm Voice Coil
• Injection-Molded Polypropylene Cone
• Co-molded Santoprene® Surround
• UniPlate™ Back Plate And Pole Piece
• Thick Tinsel Leads
• Large Ceramic Magnet
• Rear Gasketing Included
• Polymer Basket Resists Corrosion
• Protective Terminal Cap
• Stainless Mounting Hardware Included
• Meets or Exceeds ASTM Standards for UV and Salt/Fog Exposure
• Impedance: 2 Ohms
• Frequency Response: 30 Hz - 500 Hz
• Mounting Depth: 5" inches
• Hole Diameter: 9.19" inches
• Outer Diameter: 10.69" inches

---

Description of TPS-A500.1:

Hifonics THOR compact 500 watt mono Powersports amplifier to for a subwoofer with on-board equalization and simple instalation with quick release connectors.

Features:

• Hifonics TPS-A500.1 500w Mono Marine Sub Amplifier For Polaris RZR/ATV/UTV/Cart 
• Marine Grade Protection: YES - Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
  
• Pre-Amp Circuitry: Low Noise Pre-Amplifier Stage - Special preamplifier reduces incoming noise from source units dramatically improving sound quality
  
• Inputs: 1 Pair, RCA Nickel-Plated - High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
  
• Operation Mode: Mono operation - Designed to power 1 subwoofer or subwoofer system
  
• Crossover / Signal Shaping: LPF - Complete control of amplifier signal, essential when using two or more amplifiers
  
• Class / Topology: Full Range Class D - Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
  
• Output Devices Technology: PWM MOSFET Power Supply - Stable power through the PC board with minimal heat generation
  
• Heat Sink: Aluminum - Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration
  
• Power Supply: Simpatico Coil Design - The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
• Output Connections: Quick Dissconect Wires, RCA Connections - Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
  
• Connections Type: Gold-plated connections - Gold-plated power, ground, speaker and RCA corrosion resistant connections
  
• Diagnostics: Three-stage protection circuits - Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel
  
• Marinized / Waterproof: YES - Water resistant for durability in any environment
  

Specifications:

• Class: Full Range Class D
  
• Variable Voltage: 0.2V~9V
  
• Signal to Noise Ratio: >100dB
  
• Frequency Response: 10Hz-300Hz
  
• Crossover Type: Electronic 12dB Per Octave
  
• Crossover Frequency Range CH1 & CH2: Switch Low Pass 300 Hz
  
• Bass Boost: 0-12dB@45Hz
  
• Subsonic Filter: 60Hz
  
• Power @ 2-Ohms: 1 x 500W
  
• Power @ 4-Ohms: 1 x 250W
  
• Total Channels: Mono
  
• Audio Inputs: RCA
  
• Power Terminal 12v/GND: Molex 10 ga
  
• Speaker Terminal Wire Gauge: Molex Plug Connector
  
• Fusing: 1 x 30 Amps
  
• Certifications: Marine & Powersports
  
• Dimensions: 3.70 X 5.51 X 1.77 inches  (9.4 X 14.0 X 4.5 cm)
  
• Weight: 2.09 lbs (0.95 kg)

Row content