DMX3P5FT 2-Pack

This pack bundles two genuine Chauvet 5-foot, 3-pin DMX cables built specifically for lighting control signal rather than audio. A true DMX cable runs at 120 ohm impedance; standard XLR microphone cables sit around 70 ohm, and that mismatch is a common source of flickering, dropped channels, and other DMX communication problems in a rig. Each cable uses 24 AWG conductors and a male-to-female 3-pin connector, linking a console or splitter to the next fixture in a daisy chain and combining freely with other 3-pin DMX cables already in a kit. At 5 feet, the pair suits short jumps between adjacent fixtures on a truss, from a splitter to the nearest light, or as a compact spare that takes up almost no room in a gear bag. Since a DMX rig is only as reliable as its weakest cable, carrying two correctly rated short cables means never reaching for the wrong cable type just to bridge a few feet. Both cables meet the required spec for any 3-pin DMX-512 lighting system and drop straight into an existing setup.