DJM618 Gooseneck Microphone

The DJM618 Gooseneck Mic is built for speech: DJ rigs, studio talkback, webcast, and PA duty. A unidirectional cardioid pattern picks up the voice in front of it and rejects sound arriving from the sides and rear, which keeps feedback down when the mic sits near monitors and cuts the room noise that muddies announcements.

The 16.5" flexible gooseneck holds any position you bend it into, so you can aim the capsule at a talker from a podium, a DJ booth, or the edge of a console and it stays there through a long set. The built-in 3-pin male XLR connector plugs straight into the mic input on a console or mixer with no separate cable to run, coil, or lose. Power comes from the console phantom power supply.

Condenser design keeps speech clear and articulate rather than dull, which matters when you are cutting through music or reading announcements over a crowd.

Practical uses: talkback from a control room to the live room, DJ mic duty on a mixer channel in a club, a lectern mic for meetings and ceremonies, or a webcast setup where a boom arm would crowd the desk. Because the mic mounts directly in the XLR jack, it also works well in permanent installs like podiums and rack-mounted talkback panels where cable clutter is a problem.