Skip to product information
1 of 6

PLANET AUDIO

Anarchy AC1200.2 1200W 2-Channel Car Amplifier

Anarchy AC1200.2 1200W 2-Channel Car Amplifier

2-Channel Class A/B Car Amplifier, 300W RMS Per Channel, 1200W Bridged, Wired Remote Bass Control Included

Free Shipping

Regular price $77.95
Sale price $77.95 Regular price $126.00
Save 38%
Shipping calculated at checkout.
Features
    • 300W RMS x 2 at 4 ohms with 1200W bridged output for one subwoofer
    • Full-range Class A/B design runs door speakers or a sub from one amp
    • Low-pass 45-90 Hz and high-pass 50-500 Hz filters tune each speaker type
    • Variable 0 to 18 dB bass boost with included wired remote level control
    • Thermal, overload, and short-circuit protection guards amp and speakers
30-Day Money-Back Guarantee
Fast & Free Shipping
Buy Now, Pay Later
    • Anarchy AC1200.2 2-Channel Car Amplifier
    • Wired Remote Bass Level Control

SKU: SKU: AC1200.2

View full details

Product Description

The Planet Audio Anarchy AC1200.2 is a two-channel Class A/B car amplifier that powers a pair of full-range speakers or a single subwoofer. It puts out 300W RMS per channel at 4 ohms, 600W max per channel at 2 ohms, and 1200W bridged into one channel at 4 ohms, so you can run door speakers now and switch to a mono sub setup later without buying a second amp.

Tuning happens on the amp itself. A low-pass filter from 45 Hz to 90 Hz keeps a subwoofer focused on bass, while a high-pass filter from 50 Hz to 500 Hz keeps low frequencies away from smaller speakers that cannot reproduce them. Variable bass boost adds up to 18 dB when you want more low end, and the input sensitivity switch matches the amp to a factory or aftermarket head unit. The included wired remote mounts within reach of the driver's seat for bass level changes on the move.

Both RCA and high-level speaker inputs are on board, so the amp connects to a factory radio with no preamp outputs as easily as it does to an aftermarket deck. A 20 Hz to 20,000 Hz frequency response, 84 dB signal-to-noise ratio, and 90 dB channel separation keep music clear at volume. Thermal, overload, and short-circuit protection circuitry shuts the amp down before a wiring fault or high heat causes damage.

At 12" long, 10" wide, and 2.25" tall, it fits under a seat, behind a rear panel, or on an amp rack in a trunk build. A practical pick for a first upgrade over factory speakers, a two-way front stage, or a single-sub bass system in a car you use every day.

Features

    • Power For Two Kinds Of Builds

      Rated at 300W RMS per channel at 4 ohms and 1200W bridged, the amp runs a pair of full-range speakers or a single subwoofer.

    • Tuning You Control

      A 45 to 90 Hz low-pass filter and a 50 to 500 Hz high-pass filter send each speaker only the frequencies it reproduces well.

    • Bass On Demand

      Variable bass boost up to 18 dB and the included wired remote let you raise or drop low end from the driver seat between songs.

    • Works With Any Head Unit

      RCA low-level inputs, high-level speaker inputs, and an input sensitivity switch connect the amp to a factory radio or an aftermarket deck.

    • Protected Under Load

      Thermal, overload, and short-circuit circuitry shuts the amplifier down if a speaker shorts or temperatures climb, so a fault does not cost you hardware.

Technical Specifications

  • Product Type 2-Channel Car Amplifier
  • RMS Power Output 300W x 2 Channels @ 4 Ohm
  • Max Power Output 600W x 2 Channels @ 2 Ohm
  • Bridged Power 1200W x 1 Channel @ 4 Ohm
  • Amplifier Class Full Range, Class A/B
  • Low-Pass Filter 45 Hz to 90 Hz
  • High-Pass Filter 50 Hz to 500 Hz
California Proposition 65 Warning: Cancer and Reproductive harm — www.P65Warnings.ca.gov