(2) JRX212 + RVSS2-TSNL4 + XLi1500

This package covers the full speaker and amplifier side of a PA in one order: two JBL JRX212 12" two-way passive speakers, a Crown XLi1500 two-channel power amplifier, a pair of Rockville RVSS2 steel tripod stands, and two 20' 1/4" to Speakon NL-4 cables. The XLi1500 puts out 330W x 2 RMS at 8 ohms, right inside the JRX212's recommended 250W to 500W range, so the amp and speakers are matched from the start. Patch a mixer or DJ controller into the amp's balanced XLR or RCA inputs, and the rig is ready for a wedding reception, church service, school gym, or bar gig.

Each JRX212 pairs a JBL M112-8 12" woofer on a 2.5" edge-wound ribbon voice coil with a JBL 2414H-C 1" compression driver on a Progressive Transition waveguide. Together they cover 60 Hz to 20 kHz with 98 dB sensitivity and up to 128 dB maximum SPL across a 90° x 50° pattern, so vocals stay clear and the low end stays full. SonicGuard limits excess power to the high-frequency driver without cutting the audio mid-set.

Crown builds the amp with protection against shorts, no-load conditions, on/off thumps, and radio-frequency interference, plus forced-air cooling for long nights. Speakon and binding post outputs, selectable 0.775V or 1.4V input sensitivity, and stereo, parallel, or bridge-mono modes leave room to grow the system later, and signal, clip, and fault LEDs on each channel show what's happening at a glance. The RVSS2 stands are black steel, rated for 132 lb each, and pack into the included carry bag between gigs.