(2) JRX212 + XLi1500 + (2) RCSS1425

This package gives you a matched passive PA in one order: two JBL JRX212 12" two-way speakers, a Crown XLi1500 two-channel power amplifier, and two Rockville RCSS1425 25' Speakon to Speakon cables to connect them. The XLi1500 puts out 330W x 2 RMS at 8 ohms, right inside the JRX212's recommended 250W to 500W range, so there's no guesswork in pairing the amp with the speakers. Plug a mixer or DJ controller into the amp's balanced XLR or RCA inputs, run the 25' cables out to each cabinet, and you're ready for a wedding reception, band rehearsal, church service, or bar gig.

The JRX212 pulls double duty. Mount it on a 36 mm pole with its dual-angle socket for front-of-house sound, or set it on the floor as a wedge monitor so performers can hear themselves on stage. Each cabinet pairs a JBL M112-8 12" woofer on a 2.5" edge-wound ribbon voice coil with a JBL 2414H-C 1" compression driver on a Progressive Transition waveguide, covering 60 Hz to 20 kHz with up to 128 dB maximum SPL. SonicGuard limits excess power to the high-frequency driver without cutting the music.

The Crown amp runs in stereo, parallel, or bridge-mono mode, with forced-air cooling and protection against shorts, no-load conditions, on/off thumps, and RF interference. The RCSS1425 cables use 14 AWG, 100% oxygen-free copper conductors in a flexible black PVC jacket, keeping resistance low on longer speaker runs across a stage or room.