(2) JRX212 + XLi1500 + (2) RCSS1610

This package covers the core of a passive PA in one order: two JBL JRX212 12" two-way passive speakers, a Crown XLi1500 two-channel power amplifier, and two Rockville RCSS1610 10' Speakon to Speakon speaker cables. The XLi1500 puts out 330W x 2 RMS at 8 ohms, inside the JRX212's recommended 250W to 500W range, so the amp and speakers are matched from the start. The cables run from the amp's Speakon outputs straight to each speaker's NL-4 input, and a mixer or DJ controller plugs into the amp's balanced XLR or RCA inputs. That's a working system for a wedding reception, band rehearsal, church service, or bar gig without a second shopping trip.

Each JRX212 pairs a JBL M112-8 12" woofer on a 2.5" edge-wound ribbon voice coil with a JBL 2414H-C 1" compression driver on a Progressive Transition waveguide, covering 60 Hz to 20 kHz with up to 128 dB maximum SPL across a 90° x 50° pattern. SonicGuard limits excess power to the high-frequency driver without cutting the music, and a 36 mm dual-angle pole socket lets you tilt the cabinet 10° toward the crowd when it's on a stand. The Crown amp adds stereo, parallel, and bridge-mono modes, forced-air cooling for long sets, and protection against shorts, no-load conditions, on/off thumps, and RF interference.

The RCSS1610 cables use 16 AWG, 100% copper conductors for lower resistance and a black PVC jacket that stays flexible when you coil them at the end of the night. At 10' each, they fit setups where the amp sits on a table or stage near the speakers.