DMX3P25FT 3-Pin DMX Cable, 25 ft (2-Pack)

This pack bundles two genuine Chauvet 25-foot, 3-pin DMX cables built specifically for lighting control signal rather than audio. A true DMX cable runs at 120 ohm impedance; standard XLR microphone cables sit around 70 ohm, and that mismatch is a common source of flickering, dropped channels, and other DMX communication problems in a rig. Each cable uses 24 AWG conductors and a male-to-female 3-pin connector, linking a console or splitter to the next fixture in a daisy chain and combining freely with other 3-pin DMX cables already in a kit. At 25 feet, the pair covers medium-length runs, from a booth to a truss across the room or between fixtures spaced further apart on a stage, without needing a coupler to extend a shorter cable. Since a DMX rig is only as reliable as its weakest cable, carrying two correctly rated 3-pin cables at this length means fewer gaps in coverage and less improvising with mismatched cable types mid-show. Both cables meet the required spec for any 3-pin DMX-512 lighting system and drop straight into an existing setup.