KICKER 43C104 Comp 10" 300 Watt Car Audio Subwoofer Sub+Mono Amplifier+Amp Kit

This bundle covers the full signal chain for a single 10-inch bass system: a Kicker 43C104 subwoofer, a Rockville dB10 mono amplifier, and a Rockville RWK81 8-gauge installation kit to wire the two together. The 43C104 uses an injection molded SoloKon cone with 360-degree back bracing and a double-stitched surround, rated at 300W peak and 150W RMS on a single 4-ohm voice coil, with a 30Hz to 500Hz frequency response tuned for low-end output. The dB10 amplifier drives that subwoofer with a dyno-certified 200W RMS at 4 ohms and an 800W peak rating, using a high-speed MOSFET power supply and Class D circuitry for efficient power delivery without excess heat. A fully adjustable 12dB per octave crossover, subsonic filter, and bass EQ let you tune the low end to the enclosure and cabin rather than running the amp wide open. The RWK81 kit fills in everything else a clean install needs: 17 feet of 8-gauge power cable, matching ground wire, a twisted-pair RCA cable, remote turn-on wire, and a 60-amp AGU fuse, all wrapped in an abrasion-resistant jacket rated for temperatures from negative 40 to 220 degrees Fahrenheit. Because the wire gauge and fuse rating are already matched to an amplifier in this power range, there's no separate trip to figure out cable sizing. Together, the three pieces give someone building a bass system from scratch everything needed between the head unit and the subwoofer, aside from an enclosure.