Anarchy AC2000.2 2000W 2-Channel Car Amplifier
PLANET AUDIO
Anarchy AC2000.2 2000W 2-Channel Car Amplifier
Anarchy AC2000.2 2000W 2-Channel Car Amplifier
2-Channel Class A/B Car Amplifier, 400W RMS Per Channel, 2000W Bridged, Wired Remote Bass Control Included
Free Shipping
Features
- 400W RMS x 2 at 4 ohms with 2000W bridged for a single subwoofer
- MOSFET power supply holds output steady when the system is pushed hard
- Low-pass 45-90 Hz and variable high-pass 50-80 Hz filters for tuning
- Variable 0 to 18 dB bass boost with included wired remote level control
- RCA and high-level inputs connect to factory or aftermarket head units
Couldn't load pickup availability
What's Included in the box
- Anarchy AC2000.2 2-Channel Car Amplifier
- Wired Remote Bass Level Control
SKU: SKU: AC2000.2
View full details





Product Description
A MOSFET power supply feeds the output stage to hold voltage steady under load, so bass stays clean when the volume goes up. Onboard tuning includes a 45 Hz to 90 Hz low-pass filter for subwoofer duty, a variable 50 Hz to 80 Hz high-pass filter that keeps low frequencies out of smaller speakers, and variable bass boost up to 18 dB. The input sensitivity switch matches amp gain to a factory head unit or an aftermarket deck, and the included wired remote puts bass level control next to the driver.
Wiring stays flexible. RCA low-level inputs handle aftermarket source units, and high-level speaker inputs let the amp run off a factory radio with no preamp outputs. Frequency response spans 20 Hz to 20,000 Hz, signal-to-noise ratio measures 84 dB, and channel separation measures 90 dB. Thermal, overload, and short-circuit protection watches conditions and shuts the amp down if a speaker shorts or temperatures climb too high.
The chassis measures 16" long, 10" wide, and 2.25" tall, so it mounts under a seat, on a trunk amp board, or against the rear wall of a truck cab. A good match for a two-way front stage that needs real power, a single 12" subwoofer, or a second amp added to a system you have already started.
Features
-
Power For Speakers Or Subs
Rated 400W RMS per channel at 4 ohms and 2000W bridged, this amp runs a full-range pair of speakers or one subwoofer from the same chassis.
-
Steady Output Under Load
A MOSFET power supply keeps voltage consistent to the output stage, so bass notes stay clean during long sessions at high volume.
-
Crossovers Built In
A 45 to 90 Hz low-pass filter and a variable 50 to 80 Hz high-pass filter send each speaker only the frequencies it reproduces well.
-
Bass Level Within Reach
Variable bass boost up to 18 dB and the included wired remote let you adjust low end from the front seat without touching the amp.
-
Fits Any Source Unit
RCA low-level inputs, high-level speaker inputs, and an input sensitivity switch make the amp work with a factory radio or an aftermarket deck.
Technical Specifications
- Product Type 2-Channel Car Amplifier
- RMS Power Output 400W x 2 Channels @ 4 Ohm
- Max Power Output 1000W x 2 Channels @ 2 Ohm
- Bridged Power 2000W x 1 Channel @ 4 Ohm
- Amplifier Class Full Range, Class A/B
- Power Supply MOSFET
- Low-Pass Filter 45 Hz to 90 Hz
- High-Pass Filter Variable 50 Hz to 80 Hz
- Bass Boost Variable 0 to 18 dB
- Bass Level Control Wired Remote
- RCA Inputs 2 Channel
- High Level Inputs Yes
- Input Sensitivity Switchable
- Channel Operation 2/1 Channel
- Protection Thermal, Overload, Short Circuit
- Signal-To-Noise Ratio 84 dB
- Channel Separation 90 dB
- Frequency Response 20 Hz to 20,000 Hz
- Dimensions 16"L x 10"W x 2.25"H