XF-SDOTSX2

The XF-SDOTSX2 is a set of two printed cover scrims cut for ProX aluminum facades with 30" x 48" panels. Black dots on a white ground give the booth a patterned front that works for retro nights, birthday parties, baby showers, and themed corporate events.

The fabric is stretch Lycra, 90 percent polyester and 10 percent spandex, so each scrim pulls tight over a panel and conforms to the edges for a flat, finished front with no sagging. Installation is by hand, with no tools and nothing to align, so panels can be swapped between plain and printed scrims in a few minutes on site.

A pattern rather than lettering means the set is not tied to one occasion, so the same two scrims cover a wide range of bookings through the year. Because the panels are translucent under light, adding fixtures behind or inside the facade turns the printed front into a lit display, which reads clearly in photographs and in video from across the room.

When the event is over, the scrims go in the washing machine. Wash in cold water without bleach and air dry; the spandex content brings them back wrinkle-free with no ironing. Facade frames are not included with this set.

These scrim products are for temporary use only and not for permanent installation. Keep them away from open flame, direct heat, hot work, and any electrical fixtures or outlets. Factory fire retardant loses effectiveness with washing and over time, so re-treat as needed.