EV2.1000 2-Channel Car Audio Amplifier

The EV2.1000 is a full-range, two-channel Class A/B car amplifier rated at 1000W total power, built to run a pair of speakers or a single subwoofer when bridged. Output reaches 375W x 2 RMS at 2 ohms, 188W x 2 RMS at 4 ohms, and 750W x 1 RMS bridged at 4 ohms, giving you enough headroom for a front-stage upgrade or a dedicated bass channel from one chassis. Stability down to 2 ohms means it holds output under low-impedance loads instead of shutting down.

Wiring stays simple. High-level speaker inputs accept the signal straight from a factory head unit, while low-level RCA inputs connect to any aftermarket source unit's pre-amp outputs. Switchable input sensitivity matches the amp to that unit's output voltage, so your volume knob behaves the way it was designed to. Variable high-pass and low-pass filters both sweep 50 Hz to 250 Hz, and variable bass boost adds 0 to 18 dB, so the same amp can be tuned for door speakers one day and a sub the next. A remote subwoofer level control is included, letting you raise or cut bass from the front seat as tracks change.

A MOSFET power supply and linear Class A/B circuitry keep total harmonic distortion at 0.01% with a 103 dB signal-to-noise ratio and 9 Hz to 50 kHz frequency response, so music stays clean as you push volume. Thermal, overload, and short-circuit protection monitors conditions and cuts output until the fault clears, guarding the amp and the speakers connected to it.

At 9.5" L x 10" W x 2.25" H, it mounts under a seat, behind a rear panel, or on an amp rack in a car, truck, or SUV build.