JRX215 Pair + RPM870 Powered Mixer + Stands

This package puts a complete PA system in one order for DJs, bands, churches, and event hosts: two JBL JRX215 15" passive speakers, a Rockville RPM870 8-channel powered mixer, a pair of steel tripod stands, and the two 20' speaker cables that connect everything. Each JRX215 pairs a 15" low-frequency driver with a JBL 2414H-C 1" compression driver on a Progressive Transition waveguide, handling 250W continuous and 1000W peak with a 41 Hz to 18 kHz frequency range and up to 129 dB maximum SPL. SonicGuard circuitry protects the high-frequency driver from excess power without cutting out the music.

The RPM870 powers both cabinets directly at 500W x 2 RMS into 8 ohms, right inside the JRX215's recommended 250W to 500W amplifier range, so there's no separate amp to buy or rack. Six XDR2 low-noise mic preamps with switchable +48V phantom power take dynamic and condenser mics, and every channel gets a 4-band EQ, aux and FX sends, a pad, and a solo button. A 24-bit processor with 16 preset effects adds reverb, delay, and chorus, while dual 7-band graphic EQs dial in the main and monitor outputs. Bluetooth streaming and a USB port that plays back tracks or records your main mix cover playlists between sets and a recording of the show.

Setup takes minutes. The 20' 1/4" to SpeakOn NL-4 cables run from the mixer to each cabinet, and the steel tripod stands, rated for 132 lb and packed in a carry bag, lift the speakers above the crowd for wider coverage. The dual-angle pole socket on each JRX215 tilts the cabinet 10 degrees toward listeners. It's a strong fit for weddings, worship services, school events, karaoke nights, and bar gigs.